Video of my experience and installation of the DMC Fuel Pump Sender Combo Install here:
http://youtu.be/S4WLZAo7XZY
Posts: 841
DMCH Fuel Pump/Sender Combo Installation Video
Video of my experience and installation of the DMC Fuel Pump Sender Combo Install here:
http://youtu.be/S4WLZAo7XZY
Location: France
Posts: 2,462
My VIN: 16951
Club(s): (DCO) (DOA) (DCUK)
Really great video, thank you for sharing
Good idea to avoid water to leak on the electrical connector!
Location: Brea, CA
Posts: 602
My VIN: 3757
Ah... You need to do it over... you did not put the Fuel pump clamp on right... Did you see how the fuel pump lifted up and you said you had to tighten... The clamp NEEDS to go around the outer White flange of the pump... Then it will be lower, and the closing plastic will fit, without having to put you foot on it...
Craig
Location: Illinois
Posts: 2,510
My VIN: 11408
Club(s): (ADOA)
Yep, refer to this page to install the pump correctlyOriginally Posted by Silverbullet
http://dmctalk.org/showthread.php?38...r-combo!/page9
Supercharged 5.3L LS4 / Porsche 6spd 522 whp
Location: Brea, CA
Posts: 602
My VIN: 3757
Here is how it should look
Posts: 841
Yep, video pulled, back in I go, sorry guys.....
Posts: 841
The rubber sleeve around the pump assembly, how is it supposed to fit?
Location: Brea, CA
Posts: 602
My VIN: 3757
The top of the rubber has a lip edge, it fits right under the White lip edge, and the smaller part of the rubber goes into the nipple of the gas tank... when the clamp is in right, it puts pressure on the rubber and holds the pump in. The inner part of the of the clamp has a race that holds the White flange down... Did you not get the same instructions I got with pictures? I still have mine, I can fax or e-mail.
Craig
Location: Taylors SC
Posts: 5,327
My VIN: (former)05429
Club(s): (DMWC) (DCUK)
pump gasket.JPG Like this. The clamp goes around the plastic and the rubber and the lip on the tank, holds it all together.
Dave S
DMC Midwest - retired but helping
Greenville SC
Posts: 841
I had the seal correct just not the clamp. I didn't look at the instruction photo close enough, sorry.
Reply With Quote
