FRAMING JOHN DELOREAN - ON VOD
www.framingjohndeloreanfilm.com
-

Originally Posted by
Farrar
After running for five minutes or so, the engine will simply die. For the first couple of minutes, everything is great -- punch the gas, the engine revs. Oil gauge is jumpy but good. Voltmeter shows good. Everything works. Then the idle gets rough, and if you hit the gas the engine stops.
This sounds like a choke plate that isn't opening.

Originally Posted by
Farrar
I tested this again after the engine had cooled down -- even if you don't punch the gas, the engine will die. It just takes longer for it to idle to a stop.
This doesn't sound like a choke plate problem.

Originally Posted by
Farrar
... the carburetor bowl is full of fuel.
Did you pop the top off the carb to look inside? You have to be careful not to put the tab that connects the choke plate to the activation lever on backwards when the choke spring is fully expanded. It's real easy to do when putting a warm carb back together. If you put that tab on backwards, the engine won't even restart -- the choke plate will be in a totally closed bind.
Bill Robertson
#5939

Originally Posted by
Farrar
Cold engine idles fine. You can punch the gas and it revs up and settles down into idle fine.
As engine warms up (approaching the first line on the temp gauge), it starts stumbling and the idle speed drops lower and lower. Try to compensate by giving it gas, and the engine quits and will not re-start until the engine is cold again.
Farrar
Look at your choke plate.
You just did a bunch of wiring work in your engine compartment -- make sure you didn't disable the 12v line to your choke spring.
Bill Robertson
#5939
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules