FRAMING JOHN DELOREAN - ON VOD
www.framingjohndeloreanfilm.com
-
EFI DeLorean
Q & A Time...
DavidProehl - Unfortunately I do not think mechanical rolling numbers will be possible with this setup. While it would be possible to control them electronically, there will probably not be any room behind the front panel for the mechanism for it. Trying to keep with the period look, a Vacuum Fluorescent Display (like I have simulated in the picture) is the current plan for the odometer/trip meter as they were available in the early 80's. Right now I've been having trouble sourcing a simple small 6-digit unit, but that is the plan.
TTait - Yes, the odometer can be pre-set at purchase, but will not be user-configurable in the car. I am also proud of the miles on my car, having well over 100,000 on it. This way with the 6 full digits, you will actually know it now. With regards to wheel size it can technically be calibrated for anything, but it probably couldn't be user-calibrated like many of those universal speedometers you can buy. If there are one or two other tire/wheel sizes there seems to be a consensus on, I could put a user-configurable jumper in it to change the setting.
john 05141 - The goal is for it to look 99% stock at daytime. Just look at your existing cluster, and imagine an electronic odometer in place of the mechanical one. Erase the trip meter.
john 05141 and Mike - While I hadn't planned on making other colors available, there is no technical reason I couldn't do it. The green color is to match the look obtained with the HVAC decal. Many OEM gauges (including our HVAC decal) use incadescent lights with complex acrylic piping to evenly illuminate the them. Different color (ex. white at day, green at night) is obtained by a green layer on the backside of the decal. To reduce costs, I have to have a specific design for the decals and have them made in bulk. However, since this will be directly backlit with LEDs (no light-piping), the decals can be made from a single layer. The alternate color of illumination is then obtained by a specific color LED. By simply installing a different color LED in those specific spots, a different color can be obtained. Be aware though that the color of the VFD cannot be changed. It is also important to note that these will not be drop-in LEDs. They will be considered non-user-replaceable surface mount units soldered directly to the PCB. I will provide specs for LED replacement which an electronics repair specialist could perform if necessary after many many years of use.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules