FRAMING JOHN DELOREAN - ON VOD www.framingjohndeloreanfilm.com
Results 1 to 10 of 1102

Thread: Farrar's car blog

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. #11
    Banned
    Join Date:  Jun 2011

    Posts:    1,068

    Quote Originally Posted by stevedmc View Post
    ... I will not be buying anymore Airtex fuel pumps for 16510.
    I tried the Mr. Gasket (made by Prestolite) pump on one of my church's school buses, but was disappointed with its output. It only registered 4 PSI on a dash pressure gauge, dropping to zero as the needle valve opened, rendering the dash gauge useless.

    These Airtex pumps seem to be all over the map. John Marconi installed his pump Spring 2009 and is still running on it. I believe Bob Babcock is still running his first pump, including trips to Michigan and Pennsylvania. My first pump lasted Spring 2004 to Spring 2008, at which time its death was caused by a piece of sucked up epoxy (you know who's pickup screen).

    Poor Farrar, meanwhile, goes through a pump every week.

    What kind of failures are you experiencing? My epoxy killed pump just sat there like a bump on a log (didn't do anything). I lost one pump to what appeared to be bearing failure (jumped around so much it was difficult to hold in my hand). It is possible my third pump did not die (the car bogged down just as Louie and I were passing an off ramp, so we zipped off the interstate, into the gas station at the top, and threw the spare into the tank -- it could have been a gust of headwind).

    The pump currently in my tank got me Alabama to New Orleans, then went to/from Lexington, Pennsylvania, and DC twice, but I won't hesitate for a second to throw my spare in there if necessary.

    Bill Robertson
    #5939
    Last edited by content22207; 08-14-2011 at 11:11 AM.

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •