FRAMING JOHN DELOREAN - ON VOD www.framingjohndeloreanfilm.com
Results 1 to 10 of 60

Thread: DeLorean Ground Schematic

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. #11
    Banned
    Join Date:  Jun 2011

    Posts:    1,068

    The two black wires from the Lambda ECU to the bulkhead connectors were ID'd using Dave Delman's bulkhead connector diagram. Unfortunately his diagram does not correspond well to the DMC factory wiring diagram. The wiring diagram does indeed show three ground wires coming off the Lambda ECU:
    - One grounds the case (the screw on top of the harness connector)
    - One grounds Pin 5
    - One grounds Pin 16

    Tomorrow I will trace exactly which two of the above go to the bulkhead connectors, and relabel my schematic using connector color and position only (I'll use Dave's numbers). Dave does have the wires in the correct places, but I find it hard to believe that the control pressure regulator is grounded through the Lambda ECU rather than its housing.

    The four bulkhead ground wires coming off the bulkhead junction were also ID'd using Dave's diagram (notice he's left the Yellow connector blank). He does have the rear lighting ground correct, but I'm at a total loss if the auto trans connectors are ID'd properly. They're in the right positions -- I just don't know for sure what they're grounding in the trans.

    Bill Robertson
    #5939
    Last edited by content22207; 08-26-2011 at 01:19 AM.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •