Quote Originally Posted by SamHill View Post
The rest of us wouldn't mind some general conclusions about what your detective work means in terms of their theory of wiring this car.
1) It sure is helluva lot easier to ground devices on a metal bodied car (can I hear an "Amen" from the Corvette owners).
2) DMC obviously never meant the ground junctions to be user serviceable, otherwise they wouldn't have hidden the most important one in the most inaccessible location.
3) Ganging the instrument cluster with a bunch of other devices, especially the intermittent wiper motor, was a bad idea.
4) Only one 18 gauge ground wire for all the rear bulbs was another bad idea.
5) Empirical evidence indicates the front driver side grounds are inadequate:
- Melted inertia switches
- Melted fuel pump fuses
- Erratic instrument cluster behavior
6) There are only seven 12 gauge ground wires for all the electrical devices north of the rear bulkhead (plus the rear lights, and a couple of engine mounted devices) -- a mere fraction of the copper in all those positive leads. If the ground wires are in fact adequate, they are just barely so, with no margin for connection degradation.
7) Almost the entire car depends upon the cable that goes from the bulkhead bolt to the frame. If you're going to clean anything, clean it (DeLorean owners seem to be disproportionately preoccupied with the radiator bracket bolt).
8 ) On the new & improved DMCTalk, if you put an "8" and a close parenthesis next to each other the site automatically reformats them into a smiley face.
9) Conventional wisdom that the instrument cluster is grounded via the radio bracket is just plain wrong.
10) As bad as Fords are, their wiring still runs circles around a DeLorean.

I'll add more as I think of them.

Bill Robertson
#5939

Quote Originally Posted by AdmiralSenn View Post
Really? It's not hard. Propane torch, heat up terminal, fill with solder, insert cable, allow to cool, crimp.
Alternative method: drill a small hole for solder to flow through, flux the inside of the connector, insert cable, heat with a torch, flow solder in.

Bill Robertson
#5939