FRAMING JOHN DELOREAN - ON VOD
www.framingjohndeloreanfilm.com
-
TPS: I do have a TPS, which is located on the Mustang throttle body opposite the throttle cables (the body is designed for one). I’m having a problem where whenever I snug the TPS bolts down, the it no longer turns with the throttle. I’ve gone through three of these over the years of testing as this binding evenrually ruins them. I’m worried that if I make it too loose that I’ll have a vacuum leak. I’m going to try making a thicker gasket to space it a bit more and see if that fixes the binding.
From what I can tell MS 2 mostly uses the TPS for more responsive acceleration enrichment, so it’s optional in my setup, but it would be nice if it worked. I don’t recall seeing anything about “engine states” mentioned anywhere before, but I know MS 3 has some more advanced stuff, and I mostly just didn’t read anything MS 3 specific so I wouldn’t be tempted to upgrade. 
VE: will do. I had a feeling that the leftmost VE column wasn’t doing much to prevent decel stalling.
Base Idle Screw: ok. I had been planning to let the IAC completely control idle, and just close the throttle all the way, but it seems that I need to crack the throttle to get the idle up above 650. My theory was that this was the first tim is out the air filter on, and now it can’t suck enough air through just the IAC, but That doesn’t seem right. Without the air filter, it seemed to be able to idle around 790 just fine with the throttle completely closed, and with the IAC open all the way would rev to 2000, so I didn’t think I was losing any useful headroom by letting the IAC manage with a closed throttle. Of course, I haven’t actually tuned the warmup yet (I was going to let warm up auto-tune handle that, which is more likely the reason I needed to crack the throttle when the air filter was on (I literally just realized this; it makes a lot more sense than my other theory).
Anyway, I’m fine with the IAC being zero at idle to. I was watching the RPMs more than the IAC steps, so I’ll monitor that on next start.
Spark table: that’s almost completely auto-generated. I have no idea how to adjust it at all. The only cells I changed are a 2x3 block around my idle, which I set to 14.
I set the low columns to 500 and 900 but put 14 in adjacent idle cells in the theory that it would just interpolate to 14 at 790 RPM. As opposed to setting the second column to 790, as that would cause interpolation in a 3x3 grid. Or at least that’s how I understood it.
I’m good with adding more low RPM columns. I’m just not really sure how important the high ROM columns are or what values I need in those columns when I reassign. Since you noted that I have duplicate columns, can I safely just reassign the the lower columns fornidle ranges, and just interpolate the higher columns?
Thanks!
— Joe
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules