FRAMING JOHN DELOREAN - ON VOD
www.framingjohndeloreanfilm.com
-
EFI DeLorean

Originally Posted by
DMC5180
Nicely done. Are you still using the AD? Did you find an off the shelf sensor or did you need to create one?
To specifically answer the angle drive question - It was completely replaced with a variable reluctor speed sensor.
This is another rough aspect of the first prototype. I had originally hoped to simply thread the inside of the hub nut, but there were multiple problems with that. For one, there was no clearance to screw on the speed sensor to the hub nut after it was installed. The spring is way too close. Second problem, the length of the threaded section on the speed sensor was way too long to seat nicely into it even if I got around the spring clearance problem.
The solution for now, I stripped off the threads on the speed sensor and cut off almost a 1/2" of the end of it. It is still fully functional. I didn't have a positive way to secure it, so its currently held in with a combination of locktite, sillicone, duct tape, and zip ties. I disassembled another speed sensor to see how its designed. Its pretty simple so I think making a custom housing or having a professional machine shop machine the existing housing is a high probability. Next iteration will properly snap into the hub nut just like the angle drive.
A few photos showing the speed sensors, the modification (butchering?), and the rough installation.
Sensor almost fitting into hub nut, needs to go in a little further...
IMG_5065.jpg
From the inside of the nut, sticks in too far, needs to be cut down...
IMG_5067.jpg
Dry fit...
IMG_5084.jpg
Works for now, we'll see for how long...
IMG_5088.jpg
Sensor uses a smaller square key than the dustcap. Hollow brass rod for the quick adaptor...
IMG_5089.jpg
Just needed another quick trim to get the exact length needed and also providing a small amount of thermal expansion room...
IMG_5090.jpg
And the sensor itself, shave some threads and lop off the end...
IMG_5064.jpg
The inner workings of the sensor, not easly to take apart (crimped aluminum), but simple enough once inside...
IMG_5079.jpg
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules