FRAMING JOHN DELOREAN - ON VOD
www.framingjohndeloreanfilm.com
-
absotively posilutely

Originally Posted by
FABombjoy
You can PWM drive the gauge with an N-channel MOSFET. I'm using a ground-switched output on my Haltech to do the same thing. That might make the circuit simpler for arduino use.
I connect a 200-ohm resistor between the gauge sender to ground, and then the low-side driver to the gauge/resistor junction. If there is a circuit disconnect the needle points around the "E" in fuel letting you know there is an Error. Your output D/C isn't linear to gauge reading but a 4-point correction curve will get it close enough. Use the highest PWM you can for smoothest gauge movement. Then you can use a second MOSFET to trigger the low-fuel light at whatever measured fuel level you like.
For a sender I'm using a Dorman 55818 with a 2-part 3d printed adapter to set it in the stock sender hole. It's easier (imo) than fiddling around with the fuel module float arm kinematic ship in a bottle puzzle.
Thanks! That's super helpful.
Is your 200-ohm resistor connected permanently between the gauge's sender terminal and ground, in parallel with the Haltech output? And have you measured the gauge's current draw, or encountered any issues driving it directly without an additional current-limiting circuit?
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules