FRAMING JOHN DELOREAN - ON VOD
www.framingjohndeloreanfilm.com
-
absotively posilutely

Originally Posted by
FABombjoy
I measured the total current using a DC supply at about 200mA @ 14.5v. I'm not sure where you'd limit the current since you need current for the gauge to move? If you're wondering if you can drive the guage right from an ardino pin, I would not.
The 200ohm is permanent. Or will be as it's all been bench tested but the install isn't complete yet. I have a separate oil/fuel gauge that I ran a bunch of bench tests with just to be sure you could raise/lower a sender float and see the gauge respond in kind. I'll be controlling all gauges this way on my engine swap without using Tee'd senders or similar.
Also there is not really much damping on the fuel gauge so you'll want a timed average on your fuel sender sample. I expected the fuel gauge to be lazy based on prior reading but it's real-time, just not quite as twitchy as the oil gauge could be @100mA
My concern was more about short-circuit protection. I wanted to make sure that if something shorted or the MOSFET failed, it wouldn't damage anything. I added a current limiter into the circuit, but then started questioning whether I'm overengineering something simple. 
Your measurement is particularly helpful because I didn't really have a reliable baseline for the gauge's normal current draw.
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules