Quote Originally Posted by bytes311 View Post
My concern was more about short-circuit protection. I wanted to make sure that if something shorted or the MOSFET failed, it wouldn't damage anything.
If the MOSFET goes open, it points to "E" in FUEL due to the 200 ohm resistor.
If the MOSFET shorts to ground, the fuel gauge reads empty. Like as if the stock float sender was at 0 ohms.
The Arduino board's 1117 regulator has current limiting / thermal protection.
I'm not sure where an overcurrent situation occurs in this scenario unless connected to the car with micron-thickness wire