FRAMING JOHN DELOREAN - ON VOD
www.framingjohndeloreanfilm.com
-
absotively posilutely

Originally Posted by
FABombjoy
If the MOSFET goes open, it points to "E" in FUEL due to the 200 ohm resistor.
If the MOSFET shorts to ground, the fuel gauge reads empty. Like as if the stock float sender was at 0 ohms.
The Arduino board's 1117 regulator has current limiting / thermal protection.
I'm not sure where an overcurrent situation occurs in this scenario unless connected to the car with micron-thickness wire

Yeah, I was being overly cautious. I started overengineering something that's relatively straightforward.
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules