Thanks for that tip, Dave! I don't have a rear dome light fixture (the holes in the trim piece have LED strips in them) so I was unable to test this.

Farrar

I now have manually-controlled courtesy lights. I just got tired of fooling with the circuit and figured: I've got an on/off switch so I might as well use it.

Farrar

Oh, and by the way: I found out that the reason I had "daytime running lights" was because in the waning daylight one late afternoon I couldn't distinguish between red/orange and red/brown wires, so I connected them both to a green/white wire. Red/brown was correct for the HVAC panel lights, which is what I intended to go on with the key (the "HVAC panel light mod" without the need for a relay socket; simply connect and tuck the wires underneath), but red/orange went to the dash and parking lights, rendering the first stop on the headlight switch redundant. However, this was a happy accident since my headlight switch is beginning to be a problem -- I have to wiggle it to get it to turn off all the way and I figure it's only a matter of time before I have to replace it. I'd rather replace it with a hazard light switch than a new Houston switch because of cost. At that time, I will likely wire up the parking lights to come on with the key as I had previously done by accident.

No more car work until my new door struts arrive. I don't feel like dodging doors...

Farrar

My new door struts arrived today! Huzzah!

Also arrived: my new LED units for my turn signals and side markers. Now all of my exterior lights (except headlights, obviously) will be LEDs. I just have to go to AutoZone and buy the proper flasher unit.

Farrar

Speaking of LEDs, I think now that all of my courtesy lights are LEDs I will reduce the amperage of the fuse. I have an oddball 3-amp fuse lying around; I will put that in and see what happens.

Also, stay tuned for comparison pictures of original door switches and a replacement I found online.

Farrar