Having consulted elsewhere on DMCTalk and also on Facebook, it seems that John Hervey did not include the necessary 90-degree fitting on the end of his short a/c hose (the one that runs from the evaporator to the condenser). He did, however, include that "hub" which contains the high-pressure cutout switch and high-pressure release valve. If you look at the picture here, you will see the entire assembly. I have everything in that picture except for the 90-degree fitting.
I received NOS versions of the high-pressure switch and release valve with the evaporator kit I bought from Dave and Julee. However, without the adapter block I have no way of installing them, so I will need to figure out some way of adapting Hervey's parts to my system.
The fittings for that Hervey hub are exactly the same as those on the bottom left of the condenser, which is where DMC put the adapter block and high pressure relief valve on the later cars. I can install the hub in between the condenser and the hose. The only drawback is that my sight glass will be on the front of the car, and I will have to run two wires from the high pressure switch back to the harness, because the high pressure switch will be located in a different location from stock. However, it should work. I will test this theory on Saturday.




Reply With Quote
