PDA

View Full Version : Frame & Body My black clock panel doesn't fit anymore??



spikeygg
08-13-2016, 06:05 PM
So I'm putting my console back together finally. Everything is going great, I get to that darn black plate with the dimmer rheostat and clock on it and wouldn't you know it, I can't get it to sit properly. Even without considering the A/C panel. It seems that my mounting holes are too close together to even fit the plate. Take a look at these pictures, they may better explain:

Here's what it looks like when I'm trying to line up the rear holes:
45384

Here's a picture of the shifter mounting holes and the measured distance between them:
45385

Here's a pciture of the clock plate's mounting points with measurements:
45386

What am I doing wrong? I tried to adjust the little metal standoff that the clock plate mounts to but there doesn't seem to be any play in it.

Bitsyncmaster
08-13-2016, 06:28 PM
Try flipping the bracket that holds those "nuts". There is an offset one way.

Ryan King
08-13-2016, 06:29 PM
This has happened to me before.

Your center console is not seated down correctly. Check that all 6 center console mounting brackets are secured correctly. Make sure the wiring harness on either side of of the center console are routed correctly. This has to do with your center console not being aligned properly, which is why you're having an issue.

The 6 mounting brackets are as follows -
2 under the ash tray.
2 under the shifter plate
2 on either side of the radio bracket.

Hope this helps.

Patrick C
08-13-2016, 06:37 PM
Try flipping the bracket that holds those "nuts". There is an offset one way.

This.

spikeygg
08-13-2016, 06:42 PM
Try flipping the bracket that holds those "nuts". There is an offset one way.

You're the man! I looked at the bracket before I installed it but I didn't notice that it was directional. Thanks for the quick response!

Morpheus
08-13-2016, 11:59 PM
Try flipping the bracket that holds those "nuts". There is an offset one way.

Exactly.

I drew some arrows on mine so I knew which end was front got future reference.