If you're doing them in large quantity you might find yourself wishing for something a little easier to use, but for just the two at the license plate frame or other one-offs, the shim works a treat.
Printable View
Yeah, it worked pretty well just now -- I replaced the one jack-nut that was missing, and then stopped when I realized that the screws I bought are a hair too short. Three more to go, but I will have to buy more machine screws first. :lol:
BTW, when the original jack-nut fell out, it left a hole larger than original, which is why I went with 1/4"-20 machine screws. I had to push the new jacknut in with my thumb, but it didn't deform.
Also, the heads of the new screws are just big enough to fill the countersink in the license plate frame. In fact, they may stick out a hair, but I don't think anyone will notice, especially since they're black. It's too dark to get a picture now, but I will try to snap one tomorrow.
Okay, now that my girlfriend is out of town for two days, it's time for me to turn the livingroom into a workshop. ;)
First task: the loose seat studs. Do I JB-Weld them back on, or should I ask a friend of mine who has a TIG welder at his house if I can bring the seats to him? I don't know the different types of welding (TIG, MIG, is there another?) so I am not sure if his would be the right type. What do y'all think?
Any weld will be better than JB....Weld...:hmm:
TIG.
Sounds to me like JB-Weld is not an adhesive at all. Disappointing.
Anyway, I hope the guy I know with the TIG welder at his house e-mails me back.
In other news, remember the plywood behind the passenger seat? I asked a friend of mine if it would be possible to cut something that large in his shop. He said it's easy-peasy and will take a matter of minutes to cut -- all three pieces if I desire. Nice! Now I just have to wait for him to get back in town. And buy a saber saw and a sheet of 1/2" plywood. :D
Is there a template for cutting these out there somewhere? It seems like the consensus is that in most cars, there's more epoxy than wood back there and it's impossible to get the panels off without destroying them. My passenger side and center piece are OK, but the driver's side is dry rotted at the bottom where the compartment door sits, so I'd love to make a new one. But what's left of the panel is so fragile there's no way I'd get it off in a piece that could be used as a template.
I would use a tape measure to measure from the top of the panel all the way to the floor before you remove what's left of the panel, and then use that measurement when you make your marks to cut the new piece.
My driver's side wood panel is still adhered. I'd make a template for you, but 1) I can't remove it without probably cracking the fiberglass, and 2) knowing how DeLoreans were put together, no two of these wood panels are alike. :lol: