One question on this... doesn't the annoying white/grey wire to the coil come from the removed box there (Idle ECU, I believe...)?
CIS has nothing to do with ignition. They are two totally separate systems.
I am currently running with a Ford Duraspark module temporarily substituted for the Bosch ignition ECU (testing for another owner):
Attachment 2319
It's just laying loose in the ECU compartment.
Bill Robertson
#5939
Owner is in Georgia.
We don't for certain whether his Bosch unit is bad -- I just wanted to be ready in case it is (you can't buy a replacement Bosch ECU over the counter).
I do intend to make another adapter to keep in my car, for my own future contingencies. Duraspark modules are stock items at all parts houses nationwide.
To be brutally honest, I haven't noticed any difference running a Ford module versus Bosch. There's a loose wire from the Duraspark ECU that is normally attached to a starter trigger signal (not present in the Bosch harness), but my car is starting just fine without it.
Bill Robertson
#5939
The delicious tangent can be continued here:
http://dmctalk.org/showthread.php?70...arbs-thread***
Pfft -- shows you how long it's been since I watched any anime. :lol: OK, back on topic...
Bill, I'm gearing up to replicate your ground bus. Can you please explain why you used plates to connect some of the wires instead of grounding them directly to the brackets in the compartments behind the seats -- was it because the bolts were different sizes? Thanks!
Farrar
Brackets in the ECU and relay compartments are as crappy as the rest of the car (my opinion). That ground block is 1/8" thick stainless steel. The crappy (my opinion) ECU bracket merely has to hold it still, which debatably is within its realm of capability.
I have no idea what I may need to ground in the future. That's the purpose of the 1/4" center stud -- to give me a convenient, non-crappy ground point for anything I ever need to attach.
I also am using the stainless bar across the front of the car as a ground block (both ground junctions behind the headlights are tied into it with 8 gauge wire). It is attached to the radiator bracket bolt with 8 gauge wire -- that's the only part of my bus that isn't 4 gauge (ground bus originates at that bolt).
Bill Robertson
#5939