I'm getting ready to attempt this over the weekend. My master cylinder is leaking down the front of the brake booster and down along the gas tank so I really need to get it replaced (I have a new one from DMCMW laying around). I also discovered my rear calipers have the original soft lines and the calipers seem to be pretty seized so I want to replace the soft lines and try to rebuild the calipers. I know I seen a "How to" on rebuilding the calipers on here somewhere but my real question is, is there anything I should know on removing the Master cylinder? Any tips or tricks? The calipers look straight forward but again, any tips? The parking brake cables look rough but I assume its just a few pins and clips that hold them on but really not sure. Any insight would be greatly appreciated. Thanks

P.S - I am totally terrified of the snapping the hard lines