Quote Originally Posted by dmc6960 View Post
Thought I'd give an end-of-season update on the prototype I finished this spring.

All-in-all, I put a bit over 2300 miles on the car. The AC is currently not working, so didn't drive it much during the hottest summer months. Then I also lost my heater core, so I haven't been driving it much in the cooler weather either. Just can't win sometimes.

What worked well -

The backlighting! This is incredible how much more finished it makes the cluster appear. The speedometer has been the next best thing, after going for a decade without a working speedometer I now have a rock solid pointer (no bouncing!) and built it with a 140mph face to match the few cars that got a factory 140mph unit. The OLED display in place of the trip-meter has been great for not only displaying the odometer and trip meter(s), but also every other digital sensor reading that comes to the instrument cluster. There were no so software failures during operation, longest single drive between ignition cycles was probably about 2 hours, so no full fuel tank draining drive tests, but still a good workout. It has had cold operation, and hot operation, and performed well despite not all components being automotive rated yet.

What needs improvement -

I built this as a rough prototype, knowing I would need several iterations before perfecting it. Now that I've had plenty of time with version 1, I can iterate and build a 2nd version. Things that need changing are as follows...

  • OLED display location. The display in place of the trip meter, is the exact size and location of the stock trip meter on the speedometer. Unfortunately, its location leaves the display partially obscured by the tail of the pointer when the speedometer is at speed. I'll need to lower its location by a bit for the next version.
  • Stepper motor failure. I had one of the stepper motors which drive the pointers fail. This is entirely my fault though, as I had been reusing the same ones over several pre-prototype builds. It was just too much for it to handle. I'll be sure to only use brand-new stepper motors for the next build.
  • Tachometer. I built this version using a lot of pre-built modules I was able source off the internet. In the interest of proving the concept of operation more than full integrated hardware, this simplified the build quite a bit. Unfortunately I wasn't able to get the optoisolator board to work for the tachometer. An optoisolator is a component that air-gaps the electrical signal coming from the ignition coil so the extreme voltage surges do not fry the microcontrollers. I built a second one by hand using the same circuit my Megasquirt has used successfully for 16 years now. That gave me a working tach for about 50 miles before something on that failed as well, which I'm suspecting is just a poor solder joint or other loose connection. During those 50 miles, it worked great so I know the code is generally sound.
  • Light bleed. This version used a piece of clear acrylic between the front PCB and the gauge decals. I painted over the opaque areas with black paint, but it wasn't quite enough and ended up with a lot of light bleed between the gauges, and around the perimeter as well. Future versions will use black ABS as the front with cutouts only where the light needs to pass.
  • Needle illumination. The lights I used to illuminate the needles were too dim. This is a simple one though, I just need to change the load resistor for those LEDs to and brighten them up a bit. I went a little too high on them.
  • Speed sensor. As I previously posted the details about installing the speed sensor in place of the angle drive, I need to improve on how it is mounted in the car. I haven't had any issues with how I did it, its worked perfectly so far. I just can't forget that it does need much improvement.


I still need to do a write-up about the build process for this prototype in the first place. I'll get to that maybe in the next few days. Until then, if you want to see a live demo of the dash in action, here is an 18 minute overview video I made that goes over everything.
Enjoy...

Amazing work, Jim!!!