Quote Originally Posted by Mark D View Post
The meter panel that fits in the glove box is cut from 1/8" thick aluminum 6061 sheet and is flat with no bend at the bottom (as someone else posted earlier)

The overall dimensions are 15 29/32 x 4 25/32. Most of the fabricated parts on the car have 'make sense' dimensions to the whole or half inch, but the meter panel is more oddly shaped for whatever reason. Either the guy who made the part was trying to hit an exact measurement to match the glove box, or he was just a little care free with his cut lines.

The top edge of the aluminum plate is also notched out for clearance to the glove box latch mechanism. Without the notch the plate will not fit correctly in the glove box.

This photo I posted a few posts back shows the upper profile of the plate.


This is about as detailed as I can get with dimensions.
Do you know what size the round gauges are? I got one off eBay - a Phaostron that's 2.5 inches across the bezel, but obviously too small as the holes in the faceplate are 7cm that I got from Bruce, and that's the size in the sketch on here as well.

There's one more on eBay, but it's only 2 inches in diameter.


Greg