Quote Originally Posted by congerz83 View Post
I also have an idle problem... as well as an acceleration problem and a cold start problem... but I digress. My car will idle high when first started then go back to normal. Then, even after warm, it'll idle at about 2,000RPM until I punch the gas quickly. I'm guessing this has something to do with the choke. Also, at times, after awhile of driving, the car will idle very low 450-500RPM it will also stall at times in during this "mode" of operation. I'm also going to start keeping better track of my mileage because I think mine has dropped drasticly.

Also the car bogs down upon acceleration VERY heavily when you first start the car. Even during normal operation I cannot floor the accelerator without heavy "bucking" This carb conversion only has about 300miles since installation. I also changed the plugs shortly after the conversion.
It sounds a LOT like you're having the same issues that I am. I've largely traced the problem down to a potential combination of two things: the electric choke not behaving properly and opening the choke plates as it's supposed to, and the fast idle cam 'resetting' and interfering with the normal operation of the throttle plates via the throttle.

I don't know exactly WHY it's doing this (or whether it's related to the potential issue with the choke), but as I understand it the fast idle is supposed to kick down after you 'bump' the throttle to get the throttle off the fast idle cam. On mine, every time I let the throttle go back to idle, it resets the fast idle cam and bumps the idle back up to around 2,000- and also wants to climb higher continually. If I'm standing there working the linkages by hand, I can pull on the throttle and the push down on the fast idle assembly/choke and it will pop to where it's supposed to be for normal running. If I don't let the throttle all the way back to idle, it will run the way it's supposed to- but if I let go of the throttle, it will pop the choke closed and reset the fast idle cam. I'm planning on pulling off the carb to test the choke and go through the procedure for setting the fast idle cam- though I don't know how it could have gotten messed up since I've not touched any of the adjustments on it.

As for your issue with the low idle, is that with nothing (A/C, fans, stereo, lights) running or with a lot of other engine loads running? At the beginning of the summer I had a similar problem when I started driving at night when I needed the A/C on- in the 'stock' setup, our carbs don't have any kind of mechanism to bump the idle up to account for loads like the A/C and headlights so if the idle is set without the engine being loaded when everything is turned on it can drag the idle down a lot. It may just be that you need to raise the idle a bit so with everything off it idles a bit high but then idles normally with what you're usually using turned on.