Quote Originally Posted by stevedmc View Post
Float instructions are silly anyway. Just set the float to a reasonably level and the shut off valve will do its job.
Hmmm...Why do you think that the settings are often down to the 1/64" then? There is more going on than keeping it from over flowing and not running out of gas on long full throttle runs...

Quote Originally Posted by congerz83 View Post
I really need to apply maximum force as fast as I can to get the RPM to drop. Sometimes it actually takes 7-8 times to accomplish this. I'm afraid I'm going to put my foot through the floor.

Ok so the car sat since 4pm yesterday. I did NOT get a chance to adjust the carb yesterday. I figured I just give the update on today's behavior. It was a bit chilly this morning in the tri-state area. Pumped pedal twice, turned on, the car stayed on at regular "choke-less" idle without stalling. Let it run until I was ready to leave for work (10MIN). The car ran very well, but again, rpm shot up to 2000RPM once I got 1 mile down the road to the first traffic light. It's stayed like that through out most of the 15MIN ride to work.
It's easy to miss the fork when installing the choke spring and it is possible on some 2100s to flip the choke spring making it work backwards (when you look at it installed in the cap, IIRC it should be wound clockwise (looks like a 6). Could explain a lot of your problems.??? ... check this when you do the things mentioned earlier. (Also, hold the throttle 1/2 open and turn the key on and see if the choke starts off ~closed and slowly opens fully, be patient...)
If at ANY time the choke plate is floppy, the spring has missed the fork.

Quote Originally Posted by Farrar View Post
You should not have to "pump the pedal." Just touch the pedal until you hear the choke plates reset, then take your foot off the pedal and turn the key. If the car has only been sitting a day or so, there will still be plenty of fuel in the bowl.
+1/2 ;-)

Once fully on a cold engine is what every owners manual I have ever seen said (for "dumb" carburetors...primes the engine...and purges the pump)...more on cold days. Perhaps yours is running rich and/or it's been a lot warmer there???