Location: Sacramento-ish
Posts: 4,408
My VIN: 02100
Club(s): (NCDMC) (DCUK)
Jon
1981 DMC-12 #02100. July 1981. 5-speed, black, grooved w/flap.
restoration log, March 2011 to present
full and detailed photo restoration log
Location: Fort Lauderdale
Posts: 4,740
My VIN: 02613
Club(s): (DCF)
Looks like I will have to see where the old adhesive was, is, or should be when I pull the panel out next week. After that, I will have to start with plain old plywood and take it from there. Making a new fiberglass/foam sandwich panel would be awesome, but I have way too many things to do before Orlando. I would at least like to finish my console, and that is a small amount of fiberglass fabrication!
3.0L, automatic, carbureted
Location: Sacramento-ish
Posts: 4,408
My VIN: 02100
Club(s): (NCDMC) (DCUK)
Jon
1981 DMC-12 #02100. July 1981. 5-speed, black, grooved w/flap.
restoration log, March 2011 to present
full and detailed photo restoration log
Location: Fort Lauderdale
Posts: 4,740
My VIN: 02613
Club(s): (DCF)
Just thought of a great license plate: "BTTFU."
Anyway...
Funny thing: the bolt I bought to replace the body bolt in the right rear pontoon is a 10mmx1.5 bolt. However, the hex head is smaller than the original bolt: instead of 17mm, it is 5/8".
I also notice that it's Grade 10.9 -- I hope that's strong enough.
Oh, and I had a thought about threading silicone vacuum hose through the pontoon in place of the original plastic line: take the hard plastic line out, then get a piece of coat hanger and fish it through the dead space. Then push the silicone hose over the coat hanger. It'd be like using a needle to pull thread in reverse. I'll let you know how this works, if I get a chance to try it this weekend. (I have some research to do for another English paper, and the weather might not hold out, either.)
3.0L, automatic, carbureted
Location: Fort Lauderdale
Posts: 4,740
My VIN: 02613
Club(s): (DCF)
What kind of tape did you use? My car is so filthy that I can't get tape to stick to anything. It's why I haven't taken off my door panels -- I can't even get screws to stick to the end of a screwdriver with tape. The pollen in the air will, if nothing else, diminish the sticky's stickiness.
3.0L, automatic, carbureted
Location: Hill Country, TX
Posts: 1,579
My VIN: Formerly 2329
Pollen is so thick here that EVERYTHING is a light green from the pine trees. Oh yeah, I've got to be the only guy in the world that gets bird poop on his car WHILE it's in the garage. I guess those birds are avoiding all of that pollen too!
Owen
I.Brew.Beer.
Location: Fort Lauderdale
Posts: 4,740
My VIN: 02613
Club(s): (DCF)
Here it's the oak pollen which is bad. If I don't take a Zyrtec before I go outside, I start coughing like an asthmatic. It's awful!
3.0L, automatic, carbureted