Quote Originally Posted by Farrar View Post
You will end up scratching your head a lot.

The plastic piece above the battery that the electrical bracket is attached to seems to be simply glued on each side. It's very flexible. As for how the bracket is fastened to the plastic, I have no clue. There are no holes for screws under there, and besides if you used a screw to hold the bracket on, the screw would poke down into the battery compartment.

My friend Lewis and I made an appropriate wood panel in a matter of minutes with his saber saw. I am currently cutting the necessary bevels around the wood piece with my Dremel tool's router bit, and about to glue on the top piece, then drill holes in it. I might paint it black before putting it in, but I'm not sure I will considering the amount of time that would add to the project.
The relay bracket has one screw in the back and I think should have one or two on the right side. My right side screw had to be ground off so I installed one new screw more in the middle of the bracket down into the battery compartment with a nut inside the battery compartment.