Dave, I am glad to see someone has done this, because I was thinking of the same thing... good to know that you can get a nut and the end of a screw in there without interfering with battery placement.
In other news, I beveled the edges of the wood panel where necessary using my Dremel tool's router bit at the lowest speed. With that done, I applied Liquid Nails to adhere the small piece to the top rear of the panel -- I was tempted to just use wood screws, but since I had it I figured I might as well use it. I may put screws in just for peace of mind, though.
With the wood pieces set aside for the adhesive to dry, I am getting other work done: currently I am making templates for my custom console build. Here is where I am so far as I take a break for dinner.
SANY0124.jpg
I used ordinary posterboard for the templates for a couple of reasons: first, it is cheap and plentiful; second, I can cut it with ordinary scissors; third, I can fold it and rip it to shape while it is in the car; fourth, I can tape sheets of it together to make adjustments without the result being too thick to move around in the car. Of course, it was so humid outside today that it started wilting almost immediately after I took it out of the apartment, but that is not a problem so much as a surprise.
I realized that the plastic I bought from McMaster in late 2010 (when I first thought about doing the console and nothing else more important had cropped up) is too small. For the long side pieces, I need about five feet by two feet of a flexible plastic material which is easy to cut, like ABS or nylon. Is there a source someone here could recommend?
OK, never mind that question. I found TAP Plastics online. They will sell "cut to order" plastic sheets.
Nylon would be ideal, but they don't have it. My choices are PVC or ABS.
PVC at a minimum thickness of 1/8" would not have the flexibility I need, plus it would be too thick when the foam and vinyl are applied.
ABS they sell at a minimum thickness of 1/32" but I think that would be pushing it in terms of flexibility. I think 1/16" would do nicely, but they don't have that, either. My choices are 1/32", 3/32", 1/8", or incrementally greater. I will go with 3/32", I think. That should be about the thickness of the original cardboard, and also thick enough to hold the hardware I need to install into it (L-brackets, thread inserts, etc.).





Reply With Quote
