Quote Originally Posted by Farrar View Post
Quick question: how difficult is it to replace the sway bar bushings and brackets? My brackets are scratched from when the car was lowered (too much) and I would like to replace the parts in that area with Toby's kit. Do I have to watch out for springy suspension parts? Should I raise the car on jack-stands or ramps?

I am mentioning this because on another thread someone mentioned annoying front-end vibration at speed which was cured by installation of Toby's sway bar hardware kit. My car has pretty much always had that symptom so I was thinking of trying that solution. The rubber could stand to be replaced regardless.

Thanks in advance!
Easy. All you need is a wrench and for the car to be high enough for you to get under it. The sway bar will drop down about 4" when released from the crumple tube, so don't get wanged in the head by it. It's easy enough to move back into position by hand but I used a floor jack to help keep it in place while I put the brackets back on so I'd have both hands free. Not hard though.