FRAMING JOHN DELOREAN - ON VOD
www.framingjohndeloreanfilm.com
-
Administrator

Originally Posted by
congerz83
I also have an idle problem... as well as an acceleration problem and a cold start problem... but I digress. My car will idle high when first started then go back to normal. Then, even after warm, it'll idle at about 2,000RPM until I punch the gas quickly. I'm guessing this has something to do with the choke. Also, at times, after awhile of driving, the car will idle very low 450-500RPM it will also stall at times in during this "mode" of operation. I'm also going to start keeping better track of my mileage because I think mine has dropped drasticly.
Also the car bogs down upon acceleration VERY heavily when you first start the car. Even during normal operation I cannot floor the accelerator without heavy "bucking" This carb conversion only has about 300miles since installation. I also changed the plugs shortly after the conversion.
Although a bit high (depending on ambient temperature) it is normal for most carb engines to gain RPMs as it warms and require you to pat the peddle to get the linkage to drop off of the high idle cam/step...
All of your symptoms could be the carb.
Easiest first:
Cold start and/or bogg before acceleration and/or 'bucking' - classic symptoms of the spray pump failure/adjustment.
Bogg and/or buck low- starve then surge of fuel (float adjustment, carb filter, fuel filter, pump strainer, pump...), timing
Cold start and/or high idle (especially if accompanied with smoke and/or rich smell) - choke setting (opens late) may set high idle cam, sticky linkage.
High/low idle- sticky linkage.
Air/fuel adjustments (depending on carb type) can screw everything up.
Most adjustments/settings are required to be done in a specific order.
I would let it sit all night (KEY), then make certain all linkage is free. Be sure to check with throttle AND choke in all positions and combinations! Next check spray pump sprays throughout its full stroke. Check choke settings (again, it MUST sit all night..but recheck with throttle ~1/2 open after warm up also).
Then go from there...If nothing found, go back to basics (timing, vacuum leaks, fuel quality, internal carb problem (save yourself some trouble and borrow one to test with if possible.))
EDIT: RE your correction WRT choke in morning... Befor you start you should hit the pedal once to let the choke reset after cooling. It will set the fast idle then, if required. If you don't, it stays where you left it when you last touched the pedal...
Last edited by Ron; 10-24-2011 at 02:44 PM.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules