FRAMING JOHN DELOREAN - ON VOD www.framingjohndeloreanfilm.com
Results 1 to 10 of 1102

Thread: Farrar's car blog

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. #9
    Senior Member DMC5180's Avatar
    Join Date:  May 2011

    Location:  Reedsburg, WI

    Posts:    4,042

    My VIN:    5180

    Club(s):   (DMWC) (DCUK)

    Getting back to your no start from switch issue. Do a continuity check of the W/R wire between the ignition switch connector and the relay socket. You said, when you connected your meter to ground and either W/R wire you got nothing. One of the W/R wires in the socket goes to the starter so you shouldn't see anything on one wire. But the other W/R wire is from the Ignition switch. You should have seen 12V with the key in the start position. Also, the brown wire in the socket should be connected to the Blower fan breaker. I believe this was part of a service bulletin. http://www.dmcnews.com/bulletins/ST-05-2.82.html If your breaker has been replaced it may have ring terminals now. disconnect one side of the Breaker then check to see which wires are hot with the key ON. Make sure the jumper is connected the hot side.
    Last edited by DMC5180; 04-29-2012 at 01:23 AM.
    DENNIS

    VIN 5180, Frame 3652, STAGE II​, EPS​, DM-eng Solid State Solutions (RPM Rly, Dm.Lt.Mod., Fan Fail Mod. , FAN Rly, HS.Rly) , HID headlights, SPAX user since 2009, Eibach springs, M Adj. Rear LCA's, DPNW poly-sway bar kit, DMCEU LCA Stabilizer link kit, DMCMW Illuminated door sills, Aussie Illuminated SS Shifter plate, REAL MOMO EVO Steering wheel, DELOREANA Extended View Side Mirrors w/ Heaters, DELOREANA LED Door Lights.

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •