Quote Originally Posted by dmc6960 View Post
The relay coil GND should only have GND when not in gear.
Check.
Quote Originally Posted by dmc6960 View Post
The relay coil 12V should get 12V when the key is turned to start.
No.
Quote Originally Posted by dmc6960 View Post
The relay power input should be 12V at all times.
Check.
Quote Originally Posted by dmc6960 View Post
The relay power output should turn the starter (test with a jumper).
No.

A little additional info: In order to turn the starter motor, I use a wire spliced into the red/white wire at the bulkhead connector. I touch it to the positive jump post in the engine compartment and the starter motor turns every time. So I know the connection at the bulkhead is good. Not sure if that is relevant. I originally installed that wire just to have a way to start the engine from the engine compartment while working on the car, but now I have to use it all the time. It does turn the starter motor without fail, so I assume the connections at the starter motor itself are also good. Not sure if that is relevant at this stage, but I thought I'd mention it.