Ah HA! There seems to be two problems here then. Both need to be troubleshot individually.

First, your start inhibit relay not getting its coil 12V from the ignition switch. This is bad! Under the drivers side dash, you should see I think two harnesses going into the steering collumn. One of them contains all the wires for the ignition switch. Your interested in the brown one and the white/red wire. Disconnect it and test CONTINUITY on the ignition switch side. Turn key to start, you should get a connection. Next, take a jumper and connect the brown to the white/red wire (make sure your start inhibit relay is still removed). Now with that jumper in place, check for relay coil 12V at the relay socket.


Next, it would appear that supplying 12v to the relay output pin does not turn the starter. Lets test for something else then. Find your "hot start" relay socket. Its got a white/red wire. Give it 12v, does your starter engage? Test continuity between that that wire on the hot start relay socket and the start inhibit relay socket. They should be connected. After those checks, you'll need to remove the engine harness from the bulkhead connectors and test for either 12v (with everything jumped) or continuity on the bulkhead connector for the starter and the power out from the start inhibit relay socket.

Report back.

Quote Originally Posted by Bitsyncmaster View Post
Your problem is the lack of 12 volts on the relay contacts. With the relay modification that should have been done, that 12 volts was attached to the door lock circuit breaker.
Proper service bulletin mods has that relay getting its power input from the blower fan breaker, not the door lock breaker.

However the door lock breaker is a GREAT place for really good 12V testing power.